Clearwater Water Heater Odor Repair

Are you having issues with stinky odors originating from the water coming from your water heater? It can occur sometimes for a couple different reasons. Here is what Water Heater Repair Clearwater advises to do to make sure your water smells far better and to remove any undesirable taste soon.

Causes for Clearwater Water Heater Smells?

Bacteria getting into the water system is the most typical reason ones water in the home may have odors. If you home makes use of well water or cities that utilize wells for the water supply, raises the chance of this taking place.

With a water heater temperature setting of 140 degrees or more will help in minimizing the development of germs inside of the water storage tank.

The Best Ways to Get Rid of Smelly Water Odors

The following instructions demonstrate the best way to use chlorine bleach to cleanse a water heater.

The electric or gas going to the water heater tank has to first be turned off.

Next, the cold water supply off that leads to the tank needs to be shut off.

Open the hot water faucet of the kitchen area sink to allow air to get in the tank.

With a a yard hose attached to the storage tank drain valve, drain the water inside the water heater.

Then close the drain valve once it is drained.

The next step is putting in the bleach.
If the pipe for the cold water travelling in the storage tank is a flexible hose, unscrew it from the tank. Otherwise, one will have to take off the pressure relief valve, which is more involved. For electric water heaters, one of the elements can be taken out.

Use a funnel to get bleach into the opening.
Add 5 ounces of bleach per gallon of the tank ability.
So if you have a 50 gallon water heater, you will require 250 ounces of bleach, or around 2 gallons.

Hook the water line or pressure relief valve back up again

Fill the tank back up with water once again.

Close up the hot water faucet of the kitchen area faucet as quickly as all the air runs out the line.

Run all the hot water appliances till the smell of bleach is distinct. We want to eliminate the germs that are located in the water lines likewise, not just inside of the water heater.

Keep the water in the tank and water lines without using and hot water for two to three hours.

Empty the storage tank once again and refill it. This time let it stay for at least 30 minutes and yet again drain it.

Fill the tank back up. Open all the hot water fixtures and let them run up until the odor of bleach is gone.

For gas water heaters, relight the water heater pilot burner. For electric water heaters, turn the power on once again.

Also, by replacing the anode rods, or perhaps the type used can do the trick as the following video illustrates:

Additionally, by replacing the anode rods, or perhaps the type employed can work as the next video shows:

Odors from Clearwater Water Heater

What the Experts Say

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Soquel Creek Water District

How is hydrogen sulfide gas produced in a water heater?

A water heater can provide an ideal environment for the conversion of sulfate to hydrogen sulfide gas. The water heater can produce hydrogen sulfide gas in two ways – creating a warm environment where sulfur bacteria can live, and sustaining a reaction between sulfate in the water and the water heater anode.  Read more…

Minnesota Department of Health

Check out some of our other water heater tips in our blog